WingLights Wired Installation Guide
Remove the original grips from the handlebar.
Insert the clamped handlebar grips without tightening them.
Connect the plug or the wires to the power supply routing the cable through the inner part of the handlebar (please check the wire diagram).
Insert the cylindrical base of the WingLights inside the gripper ends, ensuring that the base is touching the head of the metallic structure of the handlebars.
Tighten the screw of the clamp that is closer to the base of WingLights Wired, leaving no gap between the gripper clamp and the base.
Adjust the orientation of the winglight, rotate to align the LEDs to the front and rear direction, slide the gripper with the light already clamped on it to the central part of the handlebars until the base of WL goes in contact with the metallic structure of the handlebars.
Keeping WingLights at the right orientation fasten the screw of the internal clamp.